Extremely suitable for bonding many transparent materials such as plexiglass, perspex, polycarbonate. Also glues (imitation) leather, vinyl, soft PVC
cork, canvas, textiles and many hard and soft plastics such as PVC, ABS and polystyrene. Very suitable for repairing e.g. shoes, bags, toys, book covers, nameplates or when making (hobby) handicrafts. Extremely suitable for gluing PVC pond liner. Not suitable for polystyrene foam (Tempex®, Styrofoam), polyethylene (PE) and polypropylene (PP).

Instructions for use:
Stir well before use. Preferably do not dilute Apply adhesive thinly and evenly to both surfaces using fine-toothed notched trowel (1 mm) or brush. Allow both parts to dry for 10 to 25 minutes. As soon as the adhesive no longer pulls threads together. No further correction is possible. Avoid inclusion of air bubbles. Firmly tap, roll or press the materials.
Stains/Residue: Remove wet adhesive residues immediately with Degreaser/Thinner for Bison Kit®. Dried adhesive residues can only be removed mechanically or with a paint stripper (test beforehand).
points of attention: For optimal results, both the adhesive and the parts to be bonded must be at room temperature (certainly do not process below +10°C). The final strength of the bond depends on the applied pressure. Therefore, apply as much pressure as possible over the entire surface. If the adhesive bond with porous materials comes into prolonged contact with water, the adhesive may separate from the wet substrate.